7.18 Form Release
7.18 is the precasters favourite! General purpose chemical release agent for steel moulds, formwork and concrete beds. It provides a clean and easy release or “strike” without damage or staining to either the concrete face or form. Only a very light film of the product is required which means a little product goes along way!
Coverage: Steel and wood: 20-30 square metres per litre, Concrete: 8 square metres per litre.
7.18 is stocked and supplied in 20lt containers, 200lt drums & 1000lt IBC's.
Special Properties of 7.18 Form Release:
- Provides a clean and easy release or “strike” without damage to either the concrete face or form.
- Provides protection to timber formwork, impregnating and rendering it waterproof and resistant to rot.
- In the case of steel moulds regular use will inhibit rust. • Has no adverse effect upon the form or the concrete surface.
- Allows for fast turnaround and very cost effective.
Uses of 7.18 Form Release:
- Form Release is effective on most types of moulds and formwork (including steel, timber and fibreglass) as well as being suitable as a panel bond breaker for tilt slab construction.
- While Form Release is generally used for tilt slab construction, at colder temperatures it is more advisable to use Tilt Release for this application.
Click here for Technical Data Sheet
Click here for Safety Data Sheet
7.30 Form Release
7.30 Bio-Lease is an environmentally friendly, sustainably produced general purpose release agent. The active ingredient is from a vegetable source and contains fatty acids and these weak acids react slowly with the alkalies in cement which produces water-insoluble soaps. Bio-Lease uses NZ made 100% Biodiesel as a carrier, which is manufactured using only vegetable-based oils, is fully biodegradable and is not aqua-toxic.
When applied at the recommended dosage, 7.30 leaves a dry film on the surface of the concrete, which becomes the release agent.
It is supplied in 20lt containers, 200lt drums and 1000lt IBC’s.
Special Properties:
- Provides a clean and easy release or “strike” without damage to either the concrete face or form.
- Provides protection to timber formwork, impregnating and rendering it waterproof and resistant to rot.
- In the case of steel moulds regular use will inhibit rust. • Has no adverse effect upon the form or the concrete surface.
- Safer than traditional release agents. Flash point of over 150°C
- Environmentally friendly and biodegradable.
- Far safer than traditional release agents in the event of accidental spills affecting waterways and ground water.
Uses of 7.30 Bio-Lease:
- 7.30 is effective on all types of moulds and formwork as well as being suitable as a panel bond breaker for tilt slab construction.
Click here for Technical Data Sheet
Click here for Safety Data Sheet
